
Flat Roof Repair
Membrane roofs on storefronts and offices get seam, drain, and puncture repairs.
Flat roof repair
As a Holdrege commercial roof repair contractor, we fix leaks, seams, and flashing on storefronts, offices, and shops, with lift and material plans fitted to tight lots.

Holdrege commercial roof repair often happens on buildings that share a wall with the store next door or sit on a lot with little room for a lift. That changes how we reach the roof, where materials stage, and how long the sidewalk stays clear.
Before any work, we document the roof with photos and a written scope, then agree on lift placement, parking, and work hours with you.
Older commercial buildings with shared walls leak in a few familiar places. These are the ones we repair most.
Flashing where two roofs meet at a party wall cracks or pulls loose as the buildings move differently.
We strip the failed flashing and install new counterflashing and sealant along the full length of the wall.
Debris packs the scupper box and downspout, so water backs up behind the parapet.
The scupper is cleared and resealed to the membrane, and its downspout is opened down to grade.
Layered patches from past repairs stop bonding to each other and peel back at the edges.
We cut back loose patch layers to firm membrane and install one clean repair over the area.
Curb flashing on older rooftop units sits too low, so wind-driven rain gets over it.
Curb flashing is raised and resealed, and the access panels on the unit are closed tight.
A storefront leak reaches customers, stock, and the shop next door. Here is what each repair keeps dry.
Water entering at a party wall can travel into the building next door before anyone sees it.
New wall flashing keeps the water from each roof on its own side.
Ceiling drips over display areas damage stock and close aisles until the leak stops.
A traced repair at the roof lets you reopen the area and replace ceiling tiles once.
Leaks left running on older buildings rot wood decks and soak insulation between joists.
Early repairs keep the damage to one bay of the roof deck.
Owners of older buildings often have no record of past roof work or what lies under the membrane.
Photos and a written scope give you a roof record to start from.
All four repair services reach Holdrege. Pick the one that matches your roof, or call and we will help sort it out.

Membrane roofs on storefronts and offices get seam, drain, and puncture repairs.
Flat roof repair
Metal shop and warehouse roofs get new screws, resealed laps, and replacement panels.
Metal roof repair
Leaks with no obvious source get traced from the ceiling stain back to the roof.
Roof leak repair
Plant roofs get curb, stack, and drain repairs planned around production.
Industrial roof repairTell us where the water shows and how close the next building sits. That helps us plan lift access and materials.
Each visit follows the same order, adjusted for lot size and shared walls.
We check the roof, the walls it meets, and the ceiling below, and note where a lift can safely stand.
Lift placement, parking, and work hours are set with you, along with how the entrances stay open.
Crews repair the flashing, seams, or curbs on the scope, staging materials away from customer paths.
You get photos of the finished repair added to the written scope for your building file.
Beyond Holdrege, we repair commercial roofs in Kearney and the towns listed here. If your building is somewhere else, call us or send us a message.

Answers for Holdrege owners on cost, access, shared walls, and finding a contractor nearby.
The roof type, the size of the damaged area, and any hidden damage underneath set most of the cost. Replacing a few metal fasteners is a smaller job than cutting out a membrane section over wet insulation. Lift access on a tight lot also counts. We photograph the roof and write the scope before any repair.
Repair is priced on the damaged areas only, while replacement covers the whole roof, so the two are far apart when damage stays local. Replacement comes up when the inspection finds wet insulation or failing membrane across much of the roof. The written scope shows what we would repair now and what we would watch.
Yes. We repair commercial roofs in Holdrege, and the same services cover Kearney, Minden, Gibbon, Ravenna, and Shelton. Call with the address and what you see, and we set up an inspection at a time that works around your open hours.
We treat the shared wall as its own repair area. Old counterflashing comes off, the wall and both roof edges are checked, and new flashing is installed and sealed along the full run. If the neighboring roof is part of the problem, we show you photos so the two owners can plan together.
In most cases, yes. Lift placement, material staging, and work hours are agreed before the visit so the entrance stays open. Noisy or messy steps, such as tearing out wet insulation, can be scheduled before opening or after closing.
Tell us about the building, the leak, and the space around it. We will inspect the roof and send a written repair scope.